BS-601

模拟示波器 BS-601

厂家: 日本安罗

尺寸: 162x294x352 mm

重量: 7kg

双踪20MHz示波器采用高亮度示波管

垂直灵敏度 5 mV/DIV

最高扫速 0.2μsec/DIV.

特点：

1) Component Tester

2) Wide bandwidth & high sensitivity

3) Very low power consumption

4) High sensitivity X-Y mode

5) Z axis (intensity modulation)

6) TV VIDEO SYNC Filter

7) High frequency rejection filter in the trigger circuit

8) Front panel electrical trace rotator

9) Regulated power supply circuit for accuracy

COMPONENT TESTER is the special circuit with which a single component or components in or out of actual circuit boardcan be easily tested requiring no power to drive the circuit.

The display shows FAULTS of components, size of a component value, and characteristics of components, and half-deadcomponents under a dynamic test.

SPECIFICATIONS

VERTICAL DEFLECTION

Deflection Factor 5mV to 20V/DIV on 12 ranges in 1-2-5 step with fine control.

Bandwidth DC: DC to 2OMHz(-3dB)

AC: 10Hz to 20MHz(-3dB)

Risetime Less than 17.5nsec

Overshoot Less than 3%

Input Impedance lMΩ shunted by 20pFXXX3pF(Max imput: 600Vp-p or 300V DC + AC peak)

Operating Modes Ch-A, CH-B, DUAL and ADD

Chop Frequency 200kHz approx.

Channel Separation Better than 60dB at 1 kHz

CH-B Polarity CH-B can be inverted

HORIZONTAL DEFLECTION

Frequency Response DC to 1MHz(-3dB)

Input Inpedance 1MΩ shouted by 20pF ± 3pF

Max input Voltage 300V DC + AC peak or 600Vp-p

X-Y Operation X-Y mode is selected by SWEEP TIME/DIV switch

CH-A: Yaxis

CH-B: X axis

Intensity Modulalion Z Axis: TTL Level (3Vp-p - 50V) + bright, -dark.

TIME BASE (时基)

Type Automatic and triggered. In automatic mode, sweep is obtained without input signal.

Sweep Time 0.2μsec to 0.5sec/DIV on 20 ranges in 1-2-5 step with fine control and X-Y

Magnifier X5 at all ranges

Linearity Less than 3%

TRIGGERING (触发)

Sensitivity INT: 1 DIV or more

EXT: 1 Vp-p or more

Source INT, CH-B, LINE or EXT

Triggering Level Positive and Negative, continuously variable level control Pull for AUTO

Range 20Hz to 20MHz or more

Sync AC, HF Rej, TV(each + or -)

At TV Sync TV-H(Line) and TV-V(Frame) sync are switched automatically by SWEEP TIME/DIV switch.

TV-V: 0.5sec/DIV to 0.lmsec/DIV

TV-H: 50ZZZsec/DIV to 0.2ZZZsec/DIV

OTHER SPECIFICATIONS

CRT HV APPROX-2KV

Calibration Voltage 0.5Vp-p ±5%, 1kHz Square Wave